A Youtube video has been blocked because its use was rejected in the privacy settings. If you want to view it, please adjust the privacy settings to allow Youtube service. You have the right to revoke or change your decision at any time.
The store will not work correctly when cookies are disabled.
Distribution system for underfloor heating with fully pre-wired individual room control
Completely pre-assembled for installation in the UP/AP cabinet LT
consisting of: Mounting base plate
Supply manifold with flow indicator
Return collector
pre-wired individual room control
with integrated pump logic
Built on the surface heating circuit manifold and pre-wired with one actuator per heating circuit.
230V
Connecting pipes
Insulated for connection to CAT-2
Drip protection for individual room control
integrated venting and/or draining option
per distribution bar
Each circuit also requires an additional room thermostat, e.g., RTC Comfort 230 V.
Notice
Please note that gas and electric appliances require increased mains voltage for proper operation. These appliances are not equipped with a two-pin mains plug. The installation of non-pluggable appliances must be carried out by the respective network operator or a certified specialist company, which can also assist you in obtaining any necessary approval from the relevant network operator for the installation of the appliance.
