- for the initial filling and make-up of heating systems
- Depending on the system volume, appropriate refill cartridges are to be kept available for the initial filling
- the fitting is installed in cold water pipes immediately after the system separator
- the refill water is routed through an acidic ion exchange resin
- the amount of softened water depends on the degree of hardness of the water
Stiebel Eltron heating softening fitting 230013 max. volume flow 0.3 m³/h, for initial filling/make-up
In Stock
delivery time: 1-3 working days
Shipping Cost Points: 404
Part Number: 230013
Questions about the article?
+49 241-51832611
Mon. - Thu. 8.00 am to 6.00 pm, Fri. 8.00 am to 3.00 pm
Details
Stiebel Eltron heating softening fitting 230013
Notice
Please note that gas and electric appliances require increased mains voltage for proper operation. These appliances are not equipped with a two-pin mains plug. The installation of non-pluggable appliances must be carried out by the respective network operator or a certified specialist company, which can also assist you in obtaining any necessary approval from the relevant network operator for the installation of the appliance.
Shipping information: We ship electrical products exclusively to Germany, France, Poland, Belgium, Austria, Slovenia, Spain and the Netherlands.
Product Safety
Manufacturer
STIEBEL ELTRON GmbH & Co. KG
E-Mail
info-center@stiebel-eltron.de
Address
Dr.-Stiebel-Straße 33
37603 Holzminden
Germany
** Average Wholesale Price