A Youtube video has been blocked because its use was rejected in the privacy settings. If you want to view it, please adjust the privacy settings to allow Youtube service. You have the right to revoke or change your decision at any time.
The store will not work correctly when cookies are disabled.
GID technology for increased operational reliability
Water-side radial shaft seals (2-fold) as well as oil chamber and radial shaft seal to the engine compartment
Built-in, automatically restarting, temperature-dependent motor protection
Flushing device
Continuous operation possible in the surfaced state
Motor housing and rotor shaft made of stainless steel
Pump housing and impeller made of plastic
Check valve and 90° connecting elbow (2 x 1 1/4" internal thread) included in delivery
built-in flat extraction system
Power cord with Schuko plug
VDE-tested
LGA type-tested according to DIN EN 12050
Protection class: IP 68
Clear passage: 20 mm
Flow rate: Q = 11 - 2 m³/h
Delivery head: H = 1 - 8 m
Motor power: P2 = 0.38 kW
Rotational speed: n = 2716 rpm
Current type/voltage: 230 V (W-current)
Cable length: 3 m
Cable type: H05RN-F3G0.75
Radial pressure port: 1 1/4", outside
Weight: 4.5 kg
Notice
Please note that gas and electric appliances require increased mains voltage for proper operation. These appliances are not equipped with a two-pin mains plug. The installation of non-pluggable appliances must be carried out by the respective network operator or a certified specialist company, which can also assist you in obtaining any necessary approval from the relevant network operator for the installation of the appliance.
